Malibu Boats Sunsetter/Wakesetter LXi Dokumentacja Pobierz pdf (Strona 34)

Drain Plugs

Your Malibu is equipped with two drain plugs; one located

at the transom of your boat and the other directly below

your engine/drive train. On the walkthrough open bow

models you will find an additional drain plug in the ski

locker or ballast area of your boat directly in line with

your bilge pumps.

Transom Drain Plug

This plug is located in the center of the transom at the

bottom edge, and is provided to allow for drainage of the

bilge area, when needed.

Ensure all drain plugs are secure prior to launching your boat.

Damage caused as a result of these plugs not being installed

will not be covered under your Malibu warranty.

Bilge Drain Plug(s)

A T-handled, brass bilge drain plug is located in the

engine compartment of all models. Location is normally

directly below the drive-train unit. To access, lift motor

box and look aft of the ski tow pylon, and forward of the

engine. On the V-drive models, the T-handle can be found

by lifting the rear passenger seat. The T-handle is located

just below the V-drive unit.

Be sure that both the transom and bilge drain plugs are

securely in place before placing the boat in the water.

Speedometer Pickup

Your boat is equipped with a Paddle wheel speedometer

pickup, which can be found directly under the running

surface of your boat. The paddle wheel is used to measure

static water by rotation of the paddle wheel unit. This

information is transferred to the dash computer and a

computer program converts information, and this

information is transferred to the speedometer gauge.

See troubleshooting section of this manual for basic

maintenance information.

2-14

Figure 2-24. Bilge Drain Plug

Figure 2-23. Transom Drain Plug

Figure 2-25. Thru-Hull Paddle

Wheel Pickup

Chapter 2 doc.qxd 8/26/03 5:04 PM Page 14

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 75 76

Brak uwag

Malibu Boats Sunsetter/Wakesetter LXi Dokumentacja Strona 34